Sound Comparison

COMPARING SOUND LEVELS
One factor of comfort most people don't consider is sound. How can you relax when you have a noisy system? This section provides tips on how to make sure you are getting the quietest system available.

Sound is measured in bels. Each .3 increase in bels doubles the sound power output. It would take 16 air conditioners rated at 6.8 bels to have the same sound level as one air conditioner rated at 8 bels.

Comparing Sounds
• 6.0 Bels - normal conversation
• 6.8 Bels - fan running at low speed
• 7.0 Bels - refrigerator
• 7.5 Bels - washing machine
• 8.4 Bels - garbage disposal
• 8.8 Bels - lawn mower
• 9.2 Bels - diesel truck at 10 feet

EQUIPMENT SOUND LEVELS
Carrier’s Silencer System technology, featured on all of Carrier’s Tech 2000 and Puron systems, greatly reduces noise generated from the system’s outdoor unit. Carrier systems have sound ratings as low as 69 decibels. That’s quieter than an average refrigerator. Compare that to an industry average of about 80 decibels – The difference is loud and clear!

AIR CONDITIONERS AND HEAT PUMPS
An air conditioner or heat pump sitting next to your house can create a lot of noise both inside and outside your home. To compare sound levels of different brands, ask your dealer about the bel rating of units you are considering. Bels, similar to decibels, range from 0 to 13. Most air conditioners and heat pumps operate at 8 to 9 bels; some units’ ratings are as low as 6.8. That may not sound like a wide range, but consider this: 9 bels sounds 10 times louder than 8 bels. That means one 9-bel air conditioner is as loud as 10 units rated at 8 bels. So we think taking the time to compare bel ratings is pretty sound advice. Sound levels inside your home may also be reduced by matching your outdoor unit with a variable - capacity furnace or fan coil.

FURNACES
There isn’t a standard sound rating system for furnaces, so it’s difficult to compare models.

However, models that have two-speed or variable-speed operation typically also offer lower operating sound levels, because there is less noise from the blower motor and from air turbulence at lower speeds. Carrier’s variable- capacity models even have a "ramp-up" feature that gradually introduces warm air into your ducts, helping prevent the "creaking" noises that come from ducts expanding and contracting.

Since two-speed and variable- capacity models normally run on "low" speed up to 90% of the time, you’ll find they’re a sound solution when you want to enjoy peace and quiet.

This is how you use this sound generation program to see approximately what an air conditioning unit or furnace will sound like in your home or in your yard.
Decibels are normally measured 4 feet from the sound producing device. All legitimate air conditioning manufacturers will provide you with decibel sound power levels of their condensing units and heat pumps. Sound power level ratings for furnaces are more difficult to find.

Click on the 64dB level and then turn up the volume on your computer until you can just barely hear it. It should be about the same sound level that is produced by the cooling fan on your computer. With your sound at this level for the 64dB rating, when you click the other dB ratings they should be very close to what you would hear from the actual unit.

For even more accurate results you can purchase a sound level meter (available from Radio Shack for around $35.00). Hold the sound meter approximately 2 inches away from the speaker on your computer, use the C weighing scale and you can actually read the sound power levels, therefore determining approximately how your condensing unit or furnace will sound. Just vary the volume control on your computer until the sound level meter reads the decibels that the manufacturer has given you for that unit.